Week 5
What were the goals for this week?
- 3D print remainder of motor enclosures
- Meet consistently every weekend in order to make larger progress
- Find ways to quantify the felt effect of motor
- Assembly
What was accomplished this week?
- Worked on by-hand calculations for circuitry
- DC simulations in Pspice
- CAD design of small motor enclosures
- Found data sheet on large motors with detailed information
- Air canister testing for optimal servo angles
- Scent can dispenser analysis
What are the goals for next week?
- Group meeting on Saturday
- Meet Dr. Raij on Monday
- Test Plan Document due Monday
- Print motor enclosures
- Air dispenser housing and mounts
- Acquire clamps for scent can servo testing
- Assembly
Are there any critical dependencies, open problems, or other things to be aware of for the next week?
- Power limitations of Arduino board
- Design and layout of vest
- Vest material
How many hours were spent on each goal noted above?
- Approximately 8 hours
What were the goals for this week?
- 3D print remainder of motor enclosures
- Meet consistently every weekend in order to make larger progress
- Find ways to quantify the felt effect of motor
- Assembly
What was accomplished this week?
- Worked on by-hand calculations for circuitry
- DC simulations in Pspice
- CAD design of small motor enclosures
- Found data sheet on large motors with detailed information
- Air canister testing for optimal servo angles
- Scent can dispenser analysis
What are the goals for next week?
- Group meeting on Saturday
- Meet Dr. Raij on Monday
- Test Plan Document due Monday
- Print motor enclosures
- Air dispenser housing and mounts
- Acquire clamps for scent can servo testing
- Assembly
Are there any critical dependencies, open problems, or other things to be aware of for the next week?
- Power limitations of Arduino board
- Design and layout of vest
- Vest material
How many hours were spent on each goal noted above?
- Approximately 8 hours